The objective of this experiment was further investigation of the 'Slag Pit' style furnace - tentatively described as 'Celtic Iron Age'.
Refer back to an earlier posting for the build / experiment outline.
Near the end of the main sequence - Neil Peterson probing to determine bloom size. |
Hammering on the bloom in place, using the 'Thumper'. (a) |
Top Extraction of the hot bloom. (a) |
DD 2B = 22.68 kg red iron oxide + 2.5 kg whole wheat flour + 2.75 kg forge scale
/ water to mix, then dried (typically about 10% remains)
CHARCOAL : roughly 62 kg
Mix of Maple (2/3) and Oak (1/3)
AIR : via electric blower = estimated 900 LpM, increased to 1000 LpM at 4 hours
TIME : about 2 hours from start pre-heat to fill / touching off volitiles
about 5 1/2 hours for the main sequence (to start burn down)
Initial charges : Iron rich slag (2 @ 1 kg) + Gromp fragments (2 x 1 kg)
Burn Rate : Average of 12 minutes (very consistent)
First 7 ore additions at 1 kg each
Next 3 additions at 1.5 kg each
Last 7 additions at 2 kg each
Final addition at 2.7 kg (remainder on hand)
Final Bloom, shown upside down, tuyere side to right. (b) |
BLOOM : 6.1 kg
YIELD : 22 %
QUALITY : not cut at this point, but hammer feel suggests quite dense.
TEAM : Neil Peterson / Gus Gissing / Margaret Gissing / Ben Van Eis
Next : Excavation of the slag block...
Image Credits :
a) Kelly Probyn-Smith
b) 'Gus' Gissing
No comments:
Post a Comment